Digital MR300 Antenna Analyzer Shortwave Meter 1-60M For Ham Radio Signal Test

Description

Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
Digital MR300 Antenna Analyzer Shortwave Meter 1-60M For Ham Radio Signal Test
Popular
Popular
Product Introduction
Note : the item is not inclued Built-in battery,Does not support Bluetooth
Description:
100% Brand New And High Quality
Radio enthusiasts an essential tool for entry
Test the antenna technical parameters. Can test the standing wave, impedance, capacitance and so on. Can be connected to the computer to do antenna and other graphic analysis
Power supply: External: 13.8 to 19 Volts DC, 500mA; Internal: 8xAAA 1000mAh NiMH cells. Charging time: 12 hours (charge rate 0.1C)
Measure antenna electrical parameters:
SWR, impedance (resistance + reactance), capacitance, inductance. Measure coax transmission line (SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance). Measure and determine optimum settings for tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance
Material: ABS
Colour: Black
Test frequency: 1-60M
Size: 90mm * 82mm * 30mm
Connector: M head
Power requirements:
within the positive external
12V - Driveable talent works, but can not charge the battery.
3.8V ~ 18V - can drive the talent to work normally, can also be normal for the battery charge.
Frequency Generation & Control:
1 - 60 Mhz
Source impedance: 50 Ohms
Stability: +/- 100 ppm
Spectral Purity: Harmonics down Greater than - TBD dB beyond 60 MHz
Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz
Usable Measurement Range:
SWR: 1.0 to 9.99
Impedance: approx. 5 to 2000 ohms
RF Output: Adjustable: 2.0 Volts pp (typ)
2. Controls:
Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down"
Switch: "Power On"
Connectors:
RF Out: BNC
USB: Mini-B receptacle
External power: 2.1mm Power Jack (center pin positive)
3. Instrument Capabilities:
Measure feedpoint impedance
Measure ground loss: Adjust antenna tuners and determine loss
Measure inductors and capacitors
Determine characteristic impedance of transmission line
Determine length of ¼ and ½ wave phasing lines
Coaxial Cable Loss
Determine antenna tuner loss
Measure balun loss
Measure inductor Q
Estimate quartz crystal parameters
(Because of the airspace controls
not included battery
)
Package Included:
1 x MR300 Digital Shortwave Antenna Analyzer Meter Tester
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.
Home
Electronic Component
Chips
Sensor
Arduino Module
Raspberry Pi
Digital MR300 Antenna Analyzer Shortwave Meter 1-60M For Ham Radio Signal Test
Product Introduction
Note : the item is not inclued Built-in battery,Does not support Bluetooth
Description:
100% Brand New And High Quality
Radio enthusiasts an essential tool for entry
Test the antenna technical parameters. Can test the standing wave, impedance, capacitance and so on. Can be connected to the computer to do antenna and other graphic analysis
Power supply: External: 13.8 to 19 Volts DC, 500mA; Internal: 8xAAA 1000mAh NiMH cells. Charging time: 12 hours (charge rate 0.1C)
Measure antenna electrical parameters:
SWR, impedance (resistance + reactance), capacitance, inductance. Measure coax transmission line (SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance). Measure and determine optimum settings for tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance
Material: ABS
Colour: Black
Test frequency: 1-60M
Size: 90mm * 82mm * 30mm
Connector: M head
Power requirements:
within the positive external
12V - Driveable talent works, but can not charge the battery.
3.8V ~ 18V - can drive the talent to work normally, can also be normal for the battery charge.
Frequency Generation & Control:
1 - 60 Mhz
Source impedance: 50 Ohms
Stability: +/- 100 ppm
Spectral Purity: Harmonics down Greater than - TBD dB beyond 60 MHz
Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz
Usable Measurement Range:
SWR: 1.0 to 9.99
Impedance: approx. 5 to 2000 ohms
RF Output: Adjustable: 2.0 Volts pp (typ)
2. Controls:
Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down"
Switch: "Power On"
Connectors:
RF Out: BNC
USB: Mini-B receptacle
External power: 2.1mm Power Jack (center pin positive)
3. Instrument Capabilities:
Measure feedpoint impedance
Measure ground loss: Adjust antenna tuners and determine loss
Measure inductors and capacitors
Determine characteristic impedance of transmission line
Determine length of ¼ and ½ wave phasing lines
Coaxial Cable Loss
Determine antenna tuner loss
Measure balun loss
Measure inductor Q
Estimate quartz crystal parameters
(Because of the airspace controls
not included battery
)
Package Included:
1 x MR300 Digital Shortwave Antenna Analyzer Meter Tester
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important to us. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.